«
»

Hunting Knife Filework – Vine pattern

I do not seem to be able to tie this one down and get a handle on it but here is the vine file work I put on the spine of my latest knife.

Knife back with vine file work

This entry was posted on March 27, 2010 at 3:37 am and is filed under Forging, knifemaking, metalwork. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

5 Responses to “Hunting Knife Filework – Vine pattern”

  1. Gene Smith's avatar
    Gene Smith Says:
    October 31, 2010 at 3:17 pm

    All ur knifemaking skills are intact as far as I can tell…the file work looks pretty dog-gone good, also !

    Reply
  3. E's avatar
    E Says:
    September 8, 2011 at 1:57 am

    I think its gorgeous! I love looking at all the stuff you make! It makes me feel pretend close to you 😛
    ~Niece

    Reply
  4. norman adema's avatar
    norman adema Says:
    January 5, 2012 at 12:44 am

    looks great , can you email me the measurements you used on the spine? thanks Norm

    Reply
  5. Jim's avatar
    Jim Says:
    January 5, 2012 at 6:21 pm

    Thanks Norman. I believe that I measured out 1/4″ segments if I remember correctly. I am pretty sure that I just used my round file width so the semi-circles would look right.

    Reply

Leave a reply to E Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.